The importance of gear


The importance of gears:

1: Ensure the accuracy of each tooth of the gear to make it fit perfectly, and the bite clearance is reasonable.
2: The material of the forged gear must be selected in strict accordance with the requirements. The gear on the high-power machine must be heat treated to strengthen the gear hardness.
3: Ensure the accuracy of the gear, and change as little as possible within the range of one rotation of the gear to achieve the accuracy of force transmission.
4: Plastic gears improve the reuse rate due to the selection of non-polluting materials.

Medical Industry Mass Flow Meter

Sealand is a professional manufacturer of Medical Mass Flow Meter, Medical Mass Flowmeter, Medical Coriolis Meter, Medical Flow Meter, Medical Flowmeter, ATEX, IECEx & CE approved.

There are 2 optical switches for operation. The SET and SELECT optical switches are used to navigate the transmitter display. To activate an optical switch, move your finger 1~2mm over the optical switch close to the glass.






Mark:
1. The display will timeout without any operation in 5 min.
2. During numbers input, the decimal point will come up automatically if the first digit is 0; if not 0, please activate SELECT until decimal point shows up.


The general operation is listed as follows.

On Main Interfaces

Activate SET to alternate mass and volume values.

Activate SELECT to alternate main interfaces.

Long activate SELECT to go to Setup Interface.



Long activate SET for total reset.




Back to Main Interface



Long activate SET & SELECT at the same time.




Select Submenu, Parameters & Numbers

Activate SELECT to select the submenu, parameters or numbers.

Activate SET to go to submenu or save parameters/numbers.

Save setup

Long activate SET to save the modified setup.

Back or Exit

Long activate SELECT.








Medical Mass Flow Meter, Medical Mass Flowmeter, Medical Coriolis Meter, Medical Flow Meter, Medical Flowmeter

Zhejiang Sealand Technology Co., Ltd. , https://www.sealandflowmeters.com

Posted on