![<?echo $_SERVER['SERVER_NAME'];?>](/template/twentyseventeen/skin/images/header.jpg)
Many families nowadays choose to use wood floors for decoration when decorating the ground. Because of the choice of tiles or marble, the wooden floor will be warmer and will not look cold. However, some friends have reported that after a period of time in the use of wood flooring, there will be a bulge phenomenon. What is the reason for floor bulging ? How to solve it? Let's learn about it together with Xiao Bian.
1. What is the reason for floor bulging?
a. The grass is not handled well: Before the installation of the wooden floor, the ground sand has not been cleaned, it is easy to make the ground become relatively rough. And after the floor is installed, the moisture barrier film and the balance layer on the back of the floor will be destroyed during the stamping process. The intrusion of moisture on the ground will cause the floor bulging.
b. Improper handling of moisture-proof measures in daily life: If the damper floor is not wet, the joints of the damp-proof membrane are not tightly adhered with waterproof tape. The floor is in a damp environment for a long time. After the balance layer is eroded by moisture, the moisture May enter the floor, causing damage to the floor, causing bulging.
c. There are no gaps when paving the floor: The floor ignores the principle of thermal expansion and contraction in the process of paving. After the floor is used, it is inflated by moisture. This is also a factor that causes floor bulging. . Because no space was reserved in advance, a bulge appeared on the floor surface.
2, how to solve the floor drum kit
a, before the wooden floor in the shop, we must ensure that the moisture content does not exceed the standard. Excessive water content will cause the floor to distort and warp; however, if the moisture content is too low, it will cause bagging. So it should be moderate.
b. In the process of decoration, make sure that the glue completely fills the seams. If it is not filled, the water will tend to enter the joints with less gluing when the floor is dragged, and the floor substrate will absorb moisture, resulting in local expansion and blister.
c. When replacing a new floor, the best way is to remove the deformed floorboards, then pave the floor with cement and replace it with a new one so that the floor will level off as before.
d. The wooden joists should communicate with the holes and be connected with the ventilation holes on the floor surface. There should be no less than two vent holes in the floor surface and no less than two on each side of the skirting board ventilation holes to facilitate the air. Circulation.
Xiao Bian concludes: The above is the introduction of the floor drum kit for home improvement and how to solve the floor drum kit. I hope to help everyone. At the same time, we also hope that everyone can pay attention to these small details and deal with them in a timely manner so as to avoid more serious situations in the future. It would be more troublesome.
Ningbo Kyson Cool Electronic Technology Co., Ltd. , https://www.kysonrefrigeration.com