Analysis: Reasons for motor bearing overheating

Home>Bearing knowledge>Analysis: Reasons for motor bearing overheating
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131";

Analysis: Reasons for motor bearing overheating

Source: China Bearing Network Time: 2014-01-20

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
1, the bearing is damaged. Should be replaced.
2. The rolling bearing grease is too little, too much or has iron scraps and other impurities. The bearing grease capacity should not exceed 70% of the total volume; those with impurities should be replaced.
3. The shaft and the bearing cooperate too tightly or too loosely. When it is too tight, it should be ground from the head; when it is too loose, it should be set to the shaft.
4. The bearing and the end cap cooperate too tightly or too loosely. The bearing chamber is processed when it is too tight; when it is too loose, the steel sleeve is set in the end cover.
5. The two caps or bearing caps of the motor are not properly installed. Install the end cap or bearing cap into the flat; tighten the screws.
6. The belt is too tight or the coupling is not properly installed. Adjust the belt tension; proofread the coupling.
7, the sliding bearing lubricant is too little, there are impurities or oil ring stuck. Should be refueling, new oil; repair or replace the oil ring.

Recommend to friends comments close window

Bearing related knowledge
Talking about Radiator Bearing Method Classification Oil Bearings Railway Bearings Quantitative Grease Machine
SKF Bearing's “Appearance View Strategy”
Analysis of the Causes of Failure of NSK Tapered Roller Bearings


This article links to http://
Please indicate the bearing network http://

Previous: Common terms and definitions of bearings (1)
Next: How to choose the clearance of imported bearings

Flexible Gate

Flexible lift gate is a flexible soft curtain door, inside and outside the two curtains, curtains used between the aluminum beams connected with a vertically movable rail, the roof beams have levels not in the same straight line and hangar large plants in particular be applicable. Flexible lift door installation does not take up interior space in the hole inside. When the fiest move to open the door, and finally superimposed over the hole. Off event curtain rail first and then fall down until it is completely closed.

Flexible Gate,Flexible Pvc Aircraft Folding Up Door,Steel Structure Fabric Flexiile Door,Exterior Automatic Flexible Door

Shenzhen Hongfa Automatic Door Co., Ltd. , https://www.hfautodoors.com

Posted on